世间上造雪机都是在山东大型户外造雪机人工造雪机智能喷雪机

智能喷雪机 人工造雪机
　　Snowmaker/snowdrifter

　　外形尺寸2000*1980*2600mm

　　Shape size 2000*1980*2600mm

　　重量820kg

　　Weight 820Kg

　　额定电压380v

　　Rated voltage 380V

　　主风机15kw（主风机电机二次起动）

　　Main fan 15 kW (secondary starting of main fan motor)

　　压缩机7.5kw

pressor 7.5kw

　　加热6kw

　　Heating 6 kW

　　核子器20

　　Nucleon 20

　　水喷嘴360（自动摆头35°~45°）

　　Water nozzle 360 (automatic head swing 35 ~45)

　　旋转范围360度

　　Rotation range 360 degrees

　　喷桶倾角45度

　　Spray bucket inclination 45 degrees

　　水接口2"寸

　　Water interface 2 inches

　　工作水压8-45bar

　　Working water pressure 8-45 bar

　　大出水量12-46立方米

　　Zui large water output 12-46 cubic meters

　　射程55米

　　Range 55 meters

　　实拍效果图

　　Picture effect

　　金耀造雪机参数

　　Parameters of Jinyao Snowmaker

　　外形尺寸 ：长2600mm宽1800mm高2100mm

　　Shape size: 2600 mm long, 1800 mm wide and 2100 mm high

　　风扇电机 ： 1 5 kw

　　Fan motor: 15 KW

　　空压机电机： 7.5 kw

　　Air compressor motor: 7.5 kw

　　电加热 : 0. 5kw

　　Electric heating: 0.5 kw

　　总功率 : 23kw

　　Total power: 23 kw

　　造雪喷嘴 ： 106个

　　Snow nozzles: 106

　　核子器： ： 20个

　　Nucleon: 20

　　喷嘴圈数 ： 3排

　　Number of nozzle rings: 3 rows

　　旋转角度 ： 360度

　　Rotation angle: 360 degrees

　　风筒仰角 ： 50度

　　Wind drum elevation: 50 degrees

　　造雪温度 ： -35℃～0℃

　　Snow-making temperature: - 35 ~0 C

　　出雪量 ： 50～80m3/h

　　Snow output: 50-80 m3/h

　　扬程 ： 40～120m

　　Head: 40-120 M

　　供电电压 ： 380伏

　　Power supply voltage: 380 volts

　　快接电源 ： 63A

　　Fast connection power supply: 63A

　　结构 ： 3轮胎及可旋转支架

　　Structure: 3 tires and rotatable brackets

　　金耀造雪机的优势：自动化 360°旋转 质保长 不堵塞 不结冻

　　Advantages of Jinyao Snowmaking Machine: Automation 360 degree Rotation Quality Guarantee, Non-clogging and Non-freezing

　　金耀造雪机使用与保养

　　Use and Maintenance of Jinyao Snow Maker

　　开机前检查电源连接处是否有虚连。电压是否稳定。如果是发电机组供电，持续供电不可低于380伏。阀门是否结冰堵塞。如堵塞可开启电加热进行预热。喷嘴，核子器与喷头连接处是否密封。如密封圈老化或渗漏及时更换。确保风机及空压机正转。空压机油液面保持在红线处。造雪时如有结冰要及时清理以免飞溅伤人。每次造雪前检查压力表，气压表泄压阀性能；皮带涨紧度；使用完毕后把管路内余水排清。根据当地水质适当清洗喷嘴和过滤网。轴承,螺栓,伸缩杆,转盘定期注油保持各部件润滑度。每个雪季更换一次机油和空气滤芯。

　　Check the virtual connection at the power connection before starting. Is the voltage stable? If the power supply is from a generator set, the continuous power supply shall not be less than 380 volts. Is the valve frozen and blocked? If blocked, electric heating can be turned on for preheating. Is the joint of nozzle, nucleator and nozzle sealed? If the seal ring aging or leakage timely replacement. Ensure positive rotation of fan and air compressor. The oil level of the air compressor is kept at the red line. If there is ice during snow making, it should be cleared in time to avoid splashing and injuring people. Check the performance of pressure gauge, pressure relief valve of barometer, belt tightening before each snowmaking, and drain the remaining water in the pipeline after use. Clean nozzles and filters properly according to local water quality. Bearings, bolts, telescopic rods, turntables are regularly oiled to maintain the lubrication of the components. Change the oil and air filters once every snowy season.

　　更详细参数及其它问题请来电或来厂咨询