爱德乐模具清洗机

电解超声波模具清洗机使用说明书

Electroanalysis ultrasonic mould cleaner operational instruction
一，电解超声波（塑胶模具）清洗机清洗工艺描述
Electroanalysis ultrasonic(Plastic mould)cleaner process description
1，电解超声波系统是由超声波发生系统,电解电路系统,循环过滤系统,控制系统,的金型清洗液和水性防锈剂组成。Electroanalysis ultrasonic system concludes ultrasonic occurrence system, electroanalysis circuit system, cycle filtration system, control system, special cleaning liquid and waterborne anti – rust.
1,电解洗净系统是向金属表面发射气体,用桑拿的效果除去金属表面的脏物,不纯物,还可以完全除去模具上的锈斑，积炭，瓦斯气体，树脂成分,湿气,油污,通过超声波的震动污垢剥离漂浮起来,金属模具防在阴极,即使相当小的角落里的污垢也能完全去除。Electroanaly is cleaning system: remove the dirt of the surface with the sauna effectiveness by spraying the gas towards the metal surface, it also can completely remove the rust spots, carbon deposit gas, resins, humidity and oil stains on the surface of the mould. The principle of this system is to peel off the dirt and let them floating by ultrasonic shaking to remove the dirt even though the dirt is in the relatively small corners.
2，将金属还原到原有的钢绿色,恢复金属原来的绮丽。Let the metal recover to intrinsic green
3,即使是复杂的形状也可以去除污垢。Can remove the dirt even for the complicated shapes mould
4,能完全确实的洁净去污。Can remove the dirt completely
5,有良好的除锈防锈效果。Have good anti-rust effect.
6,比人工清洗要节约一小时的时间。Can save 1 hour than manual work
7,比使用有机溶剂更环保更安全。More environmental and safe than using organic solvent
8,大大的降低了洗净后不良率。Obviously reduce the rejection rate after cleaning
工艺;Process
1,金型洗净6-15分钟_____Cleaning for 6-15 minutes
2流水洗净3分钟_________Cleaning for 3 minutes with running water
3防锈工程3分钟。Antirust engineering for 3 minutes
设备用途：用于精密塑胶模具，模块，模件，模仁，镶针，镶件，去高温积碳，去硫化物，瓦斯气体，油污，锈斑的清洗。
Equipment application: applied to precision plastic mould, module,insert, Pin,clean high temperature carbonium, clea