台历月历挂历笔记本挂历杆塑料胶圈装订机厂家价格报价

三、台历月历挂历笔记本 挂历杆 塑料胶圈 装订机的安装 Installation:


1. 用户收到机器开箱后，应根据装箱单清点，如有不符，请来信来电与我厂联系。

1. When receive the machine, please check the pack-list if any parts losing.
2. 机器安装前，应将机器表面的包装物，防锈保护层清除干净。清除时不许使用硬物铲刮，以免损坏机器表面。

2. Before installation, the machine need be clean the Rust protection layer.

3. 机器的调试与运行 Adjust and running
接通电源、气源、清理完设备上、的杂物之后可开机试运行，试运行根据目录六设备的操作篇调试至生产所需的状态生产。

After connect the power, air compressor and clean the machine, please according to menu 6 to adjust the machine.



四、台历月历挂历笔记本 挂历杆 塑料胶圈 装订机的工作流程及原理

Working Process and Principle
设备工作流程：人工上料---自动送料---自动冲孔---自动穿线压合---自动收料。

Working Process: Feed by manual---Send product automatically---Punch automatically ---Closing the wire automatically---Receive the product automatically.

设备工作原理：产品由人工放置在上料输送道上，通过链条传动到冲孔待料位，待料位光电得到信号输送停止，同时待料位待料机械手1得到夹紧信号夹紧，然后将产品移至打孔等待工位，该工位确认产品到位后理料气缸将产品整齐定位，然后通过推刀将产品分次推到冲孔工位冲孔，冲孔完成后待料机械手2夹紧、理料气缸打开、机械手2将书本移至夹紧产品移至穿线工位，穿线工位光电确认产品到位后压合，然后机械手3将装订完成的书本移至收料输送位，完成装订过程。

Principle: The worker put the book into the feed belt, then be deliver to the position to wait for punch, the light sensor in the wait position get the signal to stop send the book, when the gripper 1 get the signal to grip, then deliver the book to the position of punching, when the machine confirm the book arrive the position, the machine would neat the book, then through the push knife to push the book to punch separately, after punching, the gripper 2 grip the book the closing position, when the machine confirm the book arrive, it would close the wire in the hole, at last the gripper 3 grip the book

receive belt. it is the all working process.

济南 青岛 淄博 枣庄 东营 烟台 潍坊 济宁 泰安 威海 日照 滨州 德州 聊城 临沂 菏泽 莱芜​台历月历挂历笔记本 挂历杆 塑料胶圈 装订机

​