污水处理设施服务区污水处理电解式售后无忧

服务区污水处理设备技术参数——设备组成：

一体化污水处理设备主要有七部分组成：

1、格栅 2、缺氧池 3、生物接触氧化池 4、二沉池 5、污泥池 6、消毒池，若采用鼓风机需增加“模块化风机房”。

（1）格栅：污水进入设备前入调节池，以调节污水水质、水量，调节池有效停留时间一般为4-8小时，调节池进口处设置格栅，以拦截污水中的大颗粒杂物确保水泵正常运行，该格栅为304不锈钢材质，具有分离效果好（栅条间距2mm）、不易堵塞、使用寿命长等优点。

（2）缺氧池(污泥消化池）：缺氧池为脱氮处理而设置，经格栅分离后的污水经污水泵进入缺氧池，同时污泥池中的污泥也回流至缺氧池，缺氧池中放置公司特制 BOA 型生物填料作为反硝化细菌的载体，填料对氮、磷、硫化物去除效果好，停留时间为2小时，与后续工艺中的生物接触氧化池结合形成 A/O 法处理工艺，从而达到脱磷、脱氮的目的。

（3）生物接触氧化池：共分二级，总生化时间10小时，生物接触氧化池采用BOB 型生物组合填料，该填料比表面积大，处理负荷达14kgBOD/m3 .d，是一般填料的5-10倍，生化池采用中心廊道膜片式微孔曝气或射流曝气，污水在生化池内不断循环，充分的与填料上的生物膜相接触，达到有机物迅速降解作用。

（4）二沉池：生化后的污水进入二沉池，二沉池设计表面负荷1.0m³/㎡.hr，二沉池采用斜管沉淀，沉淀面积大，沉淀，比传统竖流式沉淀池3-5倍，侧钻孔集水槽，其集水槽排水均匀稳定，出水效果好，二沉池的污泥重力自压进入污泥池。

（5）污泥池：污泥池收集沉淀池产生的污泥，部分污泥通过污泥泵回流至缺氧池进行厌氧消化；多余的污泥仅需90天以上排一次泥（用粪车抽吸或脱水成泥饼外运）。

（6）消毒池(选用)：消毒池标准停留时间为30分钟，若是医院污水，消毒时间可增加1-1.5小时，消毒剂采用商品次氯酸钠溶液消毒方式，特制的消毒装置可根据水量的大小不断改变加药量，一般10天加药一次。

（7）模块化风机房：风机房单设置，内装二台回转式风机，能自动交替运行，单台风机无故障运行50000小时，自动控制柜、气提排泥控制器与风机房和为一体，外型美观。

公司简介：济宁天通水处理设备有限公司集研发、制造、销售为一体，是一家实力雄厚的水处理设备企业。公司从事废水处理站、废水处理工艺、废水处理设备、污水处理设施、工业废水处理设备、水处理设备、生活废水处理设备、环境废水处理设备等设备为主。我公司依靠完善的生产检测设备，稳定可靠的产品质量，产品广泛应用于环保治理的各个领域。设备现全国，并出口到日本、荷兰、俄罗斯、中东、中亚、东南亚及南美、非洲等三十多个国家和地区。“没有好，只有更好”，是天通人永远的追求。天通全体员工热诚欢迎中外朋友光临指导、洽谈业务！愿与您真诚合作，共谋环境保护的崇高事业。

联系电话：

联系人：范经理

Technical parameters of sewage treatment equipment in high speed service area: equipment composition:

The integrated sewage treatment equipment mainly consists of seven parts.

1, grille 2, anoxic pool 3, biological contact oxidation pool 4, two sink pool 5, sludge pool 6, sterilizing pool, if air blower needs to increase "modular wind machine room".

(1): grid sewage into the equipment before entering the regulation pool, to regulate water quality, water quantity, regulation pool effective residence time is 4-8 hours, set a regulation pond inlet grille, with large debris particles in the sewage interception to ensure the normal operation of the pump, the grid of 304 stainless steel material, has good separation effect (grid spacing 2mm), has the advantages of no blockage, long service life etc..

(2) (anoxic sludge digester): anoxic denitrification treatment for the setting up of the grid after separation of sewage through the sewage pump into the anoxic tank, and the sludge pool sludge is returned to the anoxic tank, anoxic tank is placed in a specially designed carrier BOA type biological denitrifying bacteria as filler, filler on nitrogen, phosphorus, sulfur removal and residence time of 2 hours, combined with biological contact oxidation process in the formation of subsequent A/O process, so as to achieve the purpose of dephosphorization and denitrification.

(3): biological contact oxidation pool is divided into two levels, the total resident time is 10 hours, the BOB type biological combined packing biological contact oxidation tank, the filler surface area, processing load of 14kgBOD/m3.D, is 5-10 times the general packing, biochemical pool by central corridor diaphragm aeration or jet aeration. Sewage circulation in biochemical pool, full contact and packing biofilms, achieve rapid degradation of organic matter.

(4): two sedimentation tank after biochemical sewage into the two pond, two sink the pond surface load 1.0m / square meters fand.Hr, with two inclined tube sedimentation pond, sedimentation area, high sedimentation efficiency, compared with the traditional erectflowdepositpond high efficiency 3-5 times, side of the hole collecting tank, the water tank water stable and good effluent effect, two sludge gravity sedimentation tank sludge tank into self pressure.

(5): the sludge pond sludge pond collected sedimentation tank sludge generated part of sludge anaerobic digestion by sludge pump returned to the anoxic pool; excess sludge is only more than 90 days in a row (tankerage suction or dehydration with mud into the mud cake Sinotrans).

(6) disinfection tank (optional): disinfection pool standard residence time of 30 minutes, if the hospital sewage, disinfection time can increase 1-1.5 hours, the disinfectant disinfection solution of sodium hypochlorite disinfection device of special goods, according to the size of the water changing dosage, a 10 day dosing time.

(7) modularized fan room: the fan room is set separately, with two rotary fans installed, it can run alternately alternately, the single typhoon machine runs 50000 hours without malfunction, automatic control cabinet, air lift mud controller and fan room are integrated, and the appearance is beautiful.

Company introduction: Jining Tian Tong Shui processing equipment Co., Ltd., which is a strong water treatment equipment enterprise, integrates R & D, manufacturing and sales. The company specializes in wastewater treatment station, wastewater treatment process, waste water treatment equipment, industrial wastewater treatment equipment, water treatment equipment, domestic wastewater treatment equipment, environmental wastewater treatment equipment and other equipment. Our company relies on the perfect production testing equipment, stable and reliable product quality, the products are widely used in all areas of environmental protection. The equipment is now selling all over the country and exported to more than 30 countries and regions, such as Japan, Holland, Russia, Middle East, Central Asia, South East Asia, South America and Africa. "No best, only better" is always the pursuit of ordinary day. Tian Tong all the staff warmly welcome Chinese and foreign friends to visit and negotiate business! We are willing to cooperate sincerely with you to conspire the lofty cause of environmental protection.

Contact phone:

Contact: Manager fan